Boyt Harness Company Signature Series Two Barrel Set Takedown Case

5.00 out of 5
(4 customer reviews)


  • Waxed canvas shell
  • Quilted flannel lining with batting
  • Side-by-sides and over/under two barrel sets
  • Fits barrels up to 30″ or 34″ long
  • Leather tip, sling and handle
  • Solid brass hardware
  • Two-way brass zipper
  • Exterior pocket
  • Limited Lifetime warranty
  • Overall height: tallest point 14″; shortest point 11.5″
  • Top pocket 2.75″ (barrel)
  • Middle pocket 3″(barrel)
  • Bottom pocket 4.75″ (stock)
  • 10″x 6″ exterior pocket

Residents of California-Proposition 65 WARNING


Additional information


30", 34"


OD Green, Khaki

4 reviews for Boyt Harness Company Signature Series Two Barrel Set Takedown Case

  1. 5 out of 5


    I really like this case for carrying around my over under shotgun. I like to carry it over my shoulder but it seems like when doing this this zipper is towards the ground which could potentially let my gun fall out. Should I be carrying it zipper side up instead?

  2. Jennifer Watson

    You are carrying it correctly. The Boyt Cases are built very durable, and are built to last. This case is utilizing the original design, and the zipper being on the bottom has not been an issue.

  3. 5 out of 5


    I have a 30 inch barrell on my O/U, whcih case do you suggest?

    • Customer Service (store manager)

      If you are looking at the take down cases, I would recommend a 34″. We recommend 2″ added to the barrel in the take down cases and 22″ from the length of the barrel for a regular gun
      Thanks, Lori

  4. 5 out of 5

    William Long (verified owner)

    This item was made very well, and I expected it to last my lifetime, I use it twice a week for trap and sporting clays and 5 stand

Add a review

Your email address will not be published. Required fields are marked *

Q: What are the dimensions of the pocket please? I have a double rifle double shotgun combination with a scope and I’d rather not leave the scope on the rifle barrels. Thanks
— Asked by Rowland Thompson on January 21, 2018
A: Hi Rowland, The measurements for the interior pockets are as follows; Top: 2.75", Middle: 3", Bottom: 4.75". The exterior pocket is 10" x 6". If you have any further questions please let us know. Thank you, Briana
Q: What is the outside dimensions on this case?
— Asked by Les on July 11, 2018
A: The tallest point of this case is 14" and the shortest point is 11.5". The length of the case will depend on the length you order
— http://Customer%20Service
Q: Does the case hold 2 over and under barrels and 1 receiver/stock? Does it work well with over and under shotguns?
— Asked by James Holtz on October 14, 2018
A: James, This case should be ok for what you are looking for. I always like to give measurements so that you can be 100% sure.The measurements for the interior pockets are as follows; Top: 2.75", Middle: 3", Bottom: 4.75".
— http://Customer%20Service
Q: if I give one of these to somebody is the lifetime warranty transferable ?
— Asked by John Heacock on November 1, 2018
A: Yes John the warranty will transfer Thanks Lori
— http://Customer%20Service
Q: I'm looking for a soft case for an O/U skeet set with 3 sets of barrels with attached forends.If you do not have them can you make one "special order"?
— Asked by Jim Boswell on February 28, 2019
A: Jim, Our takedown case will only hold 1 barrel and one stock. However we do have a Skeet Tube Set Case that will hold up to 2 barrels as well skeet tubes. Unfortunately we are not able to special orders unless you order 300 or more. Thank you Lori
— http://Customer%20Service
Q: I have a Winchester Model 12 pump. I have 2 barrels for it that I use and swap out frequently when going from skeet to sporting Clay's or trap. Will the barrel pockets hold my 2 barrels? It is the barrel, magazine tube (essentially creating and over under in size), and then the forearm. So there are 2 firearms for my setup. Eliminating the need to totally tear the gun down.
— Asked by Tyler J Riley on December 18, 2019
A: Tyler, I have updated the description to include the measurements of all 3 pockets. This should help you to determine if your barrels will fit in this case. Thanks, Lori
— http://Customer%20Service
Q: Will the barrel selves in the two barrel soft take-down case accept the barrels with the fore ends attached to the barrels?
— Asked by Jerry Richardson on March 31, 2020
A: Jerry, That will depend on the measurements of your barrels with the fore ends on them. Thanks, Lori
— http://Customer%20Service
Q: What do you prefer for 20" coach shotgun?
— Asked by JAMAR MAURICE GAUSE on October 8, 2020
A: Jamar, Is the length of your barrel 20" or the length of the gun? We usually recommend 2" added to the length of the gun for a good fit. As for a specific case for a specific gun, I am not able to answer that as I do not know. Thanks, Lori
— http://Customer%20Service
Q: Are they made in the USA ?
— Asked by Jacob on November 19, 2020
A: Jacob, They are not. Thanks, Lori
— http://Customer%20Service

Have a Question? Submit it here!